E101-P

The ETTER Engineering E101-P packaged gas booster system is designed for pumping low volumes of gas, which is not corrosive to aluminum or steel, and is used when an increase in pressure is required from the available line pressure.

The package includes a magnetic coupled drive mechanism which has no shaft or shaft seals, eliminating potential leak paths.

The E101-P has a capacity range from 0 to 1000 CFH, with a maximum available pressure of 15″W.C. added to the inlet pressure. An outlet gas pressure regulator sets a constant outlet pressure over a range of flow rates. Performance information for the standard capacity model is listed on the sizing curve.

The E101-P is designed as a “Plug and Play”™ unit and comes completely pre-piped, wired and tested for your application.

The E101-P Features: 

• Metal skid-style frame with all components mounted and wired
• UL/CSA approved gas booster pump and components
• 1/3 HP TEFC motor, 120/1/60
• 1″ NPT union ends inlet and outlet for easy installation
• NO minimum flow rate requirement – pump can be dead-headed with no adverse effects!
• Pre-plumbed check valves, bypass, and low gas pressure switch.

UL-Approved  Control Panel Includes: 

• Lights and push buttons
• Operating interlocks
• Motor starter, circuit breakers, and control relays

E101-P Sell Sheet

Contact Us

With the exception of the UL-listing, the above approval agencies are region-specific, should your local agencies require any further documentation other than our UL-listing, please contact ETTER Engineering Toll Free 1-800-444-1962 for further assistance.

For a slightly larger or higher capacity gas booster please refer to the E101-PHC model. The much larger gasPOD packaged units are also available with capacities upto 120,000 CFH and static gains of over 42′ WC.

Optional equipment includes outdoor steel transclosures, gas leak detectors, and duplex systems.